DN15-PN16-BSPT Brass Gate Valve

DN15 – PN16 – BSPT Brass Gate Valve

Technical Data Sheet

1. General Information

2. Design & Manufacturing Standards

3. Main Materials (Typical)

4. Outline Dimensions & Weight (Typical values – may vary by manufacturer)

 Dimensions above are typical references. Final dimensions may vary by manufacturer; confirm with actual product or drawing.

5. Pressure-Temperature Rating (Brass body)

Note: Brass valves are generally suitable for temperatures ≤150°C. Above 120°C, pressure must be significantly derated. PTFE packing has a maximum service temperature of approx. 150°C.

6. Performance Data

7. Ciri-ciri Utama

• Brass body – Good corrosion resistance and machinability; suitable for water and low pressure steam
• BSPT taper thread – Reliable sealing, easy installation; no need for additional sealing tape
• Non-rising stem design – Compact construction, ideal for space‑limited installations
• Full bore or reduced bore – Typically reduced bore (slightly lower flow capacity than pipe size)
• Low operating torque – Light handwheel operation
• Cost effective – Widely used in construction, HVAC, water supply and drainage

8. Installation & Operation Instructions

1. Thread connection – Apply PTFE tape or thread sealant to BSPT male threads. Screw in clockwise. Do not over‑tighten to avoid cracking the valve body.
2. Flow direction – Gate valves generally have no flow direction restriction, but it is recommended to install with the arrow (if marked) or horizontally.
3. Operasi – Turn handwheel clockwise to close, counter‑clockwise to open. Valve should be fully open or fully closed; not suitable for throttling (may erode sealing surfaces).
4. Maintenance – If stem leakage occurs, carefully tighten the packing gland nut. If leakage persists, replace the packing.

9. Ordering Information

Please provide the following when ordering:

1. Valve size (DN15), pressure rating (PN16)
2. End connection: BSPT female thread
3. Body material: Brass (specify lead‑free brass if required)
4. Stem type (non‑rising stem typical)
5. Sealing type (brass body / PTFE coated)
6. Media name, temperature, and pressure
7. Quantity and packaging requirements

JAMINAN:

SAVVY VALVES komited untuk menyampaikan kualiti produk yang luar biasa dan perkhidmatan selepas jualan tanpa bimbang. Injap kami dijamin memberikan hayat perkhidmatan minimum selama 12 bulan, di mana kami akan membekalkan semua alat ganti yang diperlukan dan arahan penyelenggaraan terperinci secara percuma. Dalam tempoh jaminan, jika sebarang kerosakan bukan disebabkan oleh manusia berlaku, kami akan menggantikan komponen tanpa kos dan menyediakan sokongan teknikal profesional. Selepas jaminan tamat, pelanggan hanya perlu membayar kos alat ganti, sementara masih mendapat manfaat daripada perkhidmatan penyelenggaraan berdiskaun. Matlamat kami adalah untuk membantu pelanggan mengurangkan kos operasi dan meningkatkan kecekapan pengeluaran melalui kualiti yang boleh dipercayai dan sokongan selepas jualan yang komprehensif. Sama ada untuk pertanyaan teknikal atau keperluan penyelenggaraan, pasukan pakar kami akan bertindak balas dengan segera untuk memastikan sistem injap anda mengekalkan prestasi optimum pada setiap masa.